Woods S27CD Manual do Operador descarregar pdf (Página 31)

Dealer Service 31

MAN0500 (3/24/2006)

NOTE: Hydraulic jack will not operate if tipped more

than 90°. Use care to prevent bending crossbar during

removal.

Crossbar Installation

1. Using emery cloth (220 or finer), remove surface

rust, Loctite

and foreign material from hub,

splined gearbox vertical shaft, and crossbar.

Refer to Figure 15.

2. Install crossbar assembly (10) on splined shaft.

Install nut (54) and align a slot with hole in splined

shaft. Torque nut to 450 lbs-ft.

3. Install cotter pin (55) through slot in nut and bend

ends over.

Figure 15. Crossbar Assembly Installation

UNIVERSAL JOINT REPAIR

Figure 16. U-Joint Exploded View

U-Joint Disassembly

1. Remove external snap rings from yokes in four

locations as shown in Figure 17.

Figure 17.

2. With snap rings removed, support drive in vise,

hold yoke in hand and tap on yoke to drive cup up

out of yoke. See Figure 18.

Figure 18.

3. Clamp cup in vise as shown in Figure 19 and tap

on yoke to completely remove cup from yoke.

Repeat Step 2 and Step 3 for opposite cup.

Figure 19.

1. Yoke

2. Cup and bearings

3. Snap ring

4. Journal cross

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 51 52

Sem comentários

Woods S27CD Manual do Operador Página 31